FREE SHIPPING OVER $100* U.S. Only
New Ecommerce store as of 10/30/23
TROUBLESHOOTING HELP REQUESTED! Please [Contact us] if you find a bad link or get an error message, etc, and send us info about what page or item you were on when you saw the issue, with a link if possible, or a screen shot. Not the error screen, we need to know where you were before the error and what you were clicking on. Thanks! ~Mo, Parts & Tech Support
| Aftermarket Part - Not Manufactured by Penn Pro Challenger's Custom Gear Sleeve |  |
IMPORTANT!
On the Jigmaster reels, there are older and newer versions of the shaft that the sleeve sits on.
See photo comparison in the bridge/sleeve section of the online tutorial (Under "Sleeve Binding On Bridge")
https://scottsbt.zendesk.com/hc/en-us/articles/203439809-Penn-500-Jigmaster-Rebuild#Bridge
On the newer, thicker necked shaft, the pin for the 98-60PRO and 98-505PRO sleeve may need to be ground down on one edge, then inserted with the ground/flat edge towards the shaft, in order to get the pin in the sleeve past where the thicker neck protrudes.
Related Products
10-60 Star Drag Wheel (COARSE Thread - Two Types)
REPLACES ORIGINAL NUMBER 10-140 ON SOME REELS
$5.40
is also our credit card processor
under our MysticParts account
for all purchases as of 1/19/2024
12/21/2023 Got it! Its perfect. Thank you so much. It was just on a whim that I even searched for this part. Hard to believe that I could get a reel part for a reel that is 30 plus years old. Thanks again,
1/16/2024 Comprehensive parts list, easy to order, and prompt service. I will definitely use them again.
1/4/2024 Quite a few years doing business with great folks. Simply the best. Thanks for your commitment to the business 👍
+(COARSE+THREAD)+416+Stainless+(CUSTOM)){kind=link}